在舆论指责国内油价虚高的______见诸报端后，中石化派出一位所谓的专家拿裸油价进行比较，试图证明

- map fred with the redistribute ospf 2 command. R1 has learned intra - area routes for 10.1.1.0/24 and10.1.2.0/24 in part due to the Type 2 LSAs known for each subnet. The route map filters route 10.1.1.0/24 and allows 10.1.2.0/24 througH.Which of the following co mmands on router R1 list subnet 10.1.1.0/24？（）

A. show ip route

B. show ip eigrp topology

C. show ip ospf topology

D. show ip eigrp topology 10.1.1.0/24

A．RIP

B． BGP

C． IS - IS

D． OSPF

E． EIGRP

A. Let the metrics default.

B. Use each redistributed route‘s OSPF metric using the redistribute command‘s metric transparent keywords.

C. Set the metric using the default - metric router subcommand.

D. Redistribution is not allowed between two OSPF p rocesses.

A.R1 can learn EIGRP routes from R2, but R2 cannot learn EIGRP routes from R1

B.R1 can send IP packets to R2, but R2 cannot send IP packets to R1

C.R2 no longer learns EIGRP routes from R1 for routes not connected to R1

D.R1 no longer replies to R2‘s Query messages

E.R2n o longer sends to R1 Query messages

1.1.0/24 and 10.2.2.0/24,are not being redistributed into the OSPF routing domain. Which two items could be a solution to this proble m？（）

A. Change the EIGRP AS number from 100 to1 in the redistribute command.

B. Add the subnets option to the redistribute command.

C. Change the metric - type to2 in the redistribute command.

D. Configure the redistribute command under router eigrp 1 i nstead.

E. Change the metric to an EIGRP compatible metric value (bandwidth, delay, reliability, load, MTUs) in the redistribute command.

rk. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table？（）

A. the OSPF route

B. the EIGRP route

C. the RIPv2 route

D. all three routes

E. the OSPF and RIPv2 routes

redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem？（）

A. The no auto - summary command needs to be added under router eigrp 1

B. The subnets keyword was not included in the redistribute command under router ospf 1

C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A

D. The default - information originate command needs to be added under router ospf 1

E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF

route - map is listed next. Which of the following answers must be true based on the configuration as shown？（）route - map fred deny 10match ip address oneroute - map fred deny 20match ip address tworoute - map fred permit 100

A. The third route map clause will allow any routes not already filtered by the first two clauses

B. R outes permitted by ACL "two" will be redistributed

C. Routes denied by ACL "one" will be redistributed

D. All routes will be filtereD

A. Router R1 will advertise connected and summary routes only.

B. The eigrp stub command will automatically enable summarization of routes on R2.

C. Router R1 is configured as a receive - only neighbor and will not send any connected, static, or summary routes.

D. The eigrp stub command prevents all routes except a default route from being advertised to R1.

E. The eigrp stub command prevents queries from being sent from R2 to R1.

F. Router R1 will advert ise connected and static routes. The sending of summary routes will not be permitted.

d OSPF.The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains. Which change to router B would accom plish these goals？（）

A. Under the EIGRP process, insert the distribute - list block_net_1 out ospf 1 command.

B. Under the OSPF process, insert the distribute - list block_net_1 in serial1/0 command.

C. Under the EIGRP process, insert the distribute - list block_net_1 in serial1/0 command.

D. Under the OSPF process, insert the distribute - list block_net_1 out eigrp 1 command.