李某与陈某在办理会计工作交接手续时，应当由（)负责监交。A．其他会计人员B．会计机构负责人C．单位负

A. The no auto - summary command has not been issued under the EIGRP process on both routers.

B. Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24.

C. EIGRP cannot exchange routing updates with a neighbor‘s router interface that is configured with tw o IP addresses.

D. EIGRP cannot form neighbor relationship and exchange routing updates with a secondary address.

ed in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4？（）

A. Network B

B. Network A and Network B

C. Network A

D. neither Network A nor Network B

A. Do not fragment has been configured on PE11.

B. MPLS has been disabled on routers P11 and P12.

C. An access list has been created on P11 to block traceroutes from PE11.

D. The no mpls ip propgate-ttl local command has been configured on PE11

E. ICMP has been disabled on the intermediary routers between PE11 and PE12.

IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached？（）

A.VLANs have not been created yet

B.An IP address must be configured for the port

C.The port is currently configured for access mode

D.The correct encapsulation type has not been configured

E.The no shutdown command has not been entered for the port

trator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths？ （）

A. 1

B. 2

C. 3

D. 4

E. 5

A. R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1

B. R4(config)# ip default - network 10.0.0.0

C. R4(config - router)# default -information originate

D. R4(conf ig)# ip route 10.0.0.0 255.0.0.0 10.1.1.1

Refer to the exhibit. A network associate has configured OSPF with the command:City(config-router) network 192.168.12.64 0.0.0.63 area 0After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement？ （）

A.FastEthernet0 /0

B.FastEthernet0 /1

C.Serial0/0

D.Serial0/1.102

E.Serial0/1.103

F.Serial0/1.104

uto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3？（）

A. 10.0.0.0/8

B. 172.16.10.0/24

C. 172.16.0.0/24

D. 10.10.10.0/24

E. 172.16.0.0/16

F. 10.10.0.0/16

A.No dynamic interior routing protocol can summarize as shown

B.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibit

C.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization points

D.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy

d metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the delay metric is used in the path calculations. Which router will R1 select as the successor and feasible successor for Network A？（）

A. R 4 becomes the successor for Network A and will be placed in the routing table. R2 becomes the feasible successor for Network A

B. R4 becomes the successor for Network A and will be included in the routing table. No feasible successor will be selected a s the advertised distance from R2 is higher than the feasible distance

C. R2 becomes the successor and will be placed in the routing table. R4 becomes the feasible successor for Network A

D. R2 becomes the successor and will be placed in the routing t able. No feasible successor will be selected as the reported distance from R4 is lower than the feasible distance