世界贸易组织争端解决机制建立在《关于争端解决规则与程序的谅解书》的基础上，根据该谅解书，下列哪项不属于争端解决的基本程序：

A. The count parameter creates a counter that you can view with the show firewall command

B. The count parameter allows the router to count the number of pings for logging purposes

C. The count parameter allows the router to pause for 10000 seconds before sending out a ping

D. The count parameter allows the router to send out 1000 pings and then stop

A. The bypass-routing parameter is used to test the density on the T1 line.

B. The bypass-routing parameter cannot be used on a T1 interface.

C. The bypass-routing parameter allows you to ping a host through an interface that has no route through it.

D. The bypass-routing parameter allows you to ping a local WAN interface without generating any outbound traffic.

wn" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be？（）

A. Serial 0 is up, line protocol is up

B. Serial 0 is up, line protocol is down

C. Serial 0 is down, line protocol is down

D. Serial 0 is down, line protocol is up

E. Serial 0 is administratively down, line protocol is down

F. Serial 0 is administratively down, line protocol is up

A.show ip access-list

B.show access-list

C.list ip interface

D.show interface

E.show ip interface

A. set interface fe-0/0/0.0

B. set interface fe-0/0/0.0 all level

C. set interface fe-0/0/0.0 level 3 enable

D. set interface fe-0/0/0.0 level 1 level 2

A.ping atm vci 0.100 interface at-0/1/0 end-to-end

B.ping atm vci 0.100 interface at-0/1/0 circuit

C.ping atm vci 0.100 interface at-0/1/0 far-end

D.ping atm vci 0.100 interface at-0/1/0 final-hop

A. Show interface lmi

B. Show frame-relay lmi

C. Show interface frame-relay

D. Debug frame-relay interface.

sh to see the layer 1 and layer 2 status of the interface.Which of the following IOS commands would you issue to check the current IP addressing, as well as theyer 1 and layer 2 status of an interface？（）

A. TK1# show version

B. TK1# show protocols

C. TK1# show interfaces

D. TK1# show controllers

E. TK1# show ip interface

F. TK1# show startup-config

A. The count parameter creates a counter that you can view with the show firewall command.

B. The count parameter allows the router to count the number of pings for logging purposes.

C. The count parameter allows the router to pause for 1000 seconds before sending out a ping.

D. The count parameter allows the router to send out 1000 pings and then stop.