（）interface is used to communicate between NCP and MCU of all boards of this network element

Whistles could also be used to communicate between adult dolphins and baby dolphins.

A．Right

B．Wrong

C．Not mentioned

A.a switch with a trunk link that is configured between the switches

B.a router with an IP address on the physical interface that is connected to the switch

C.a switch with an access link that is configured between the switches

D.a router with subinterfaces configured on the physical interface that is connected to the switch

unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs？（）

A.a router with subinterfaces configured on the physical interface that is connected to the switch

B.a router with an IP address on the physical interface connected to the switch

C.a switch with an access link that is configured between the switches

D.a switch with a trunk link that is configured between the switches

Whistles could also be used to communicate between adult dolphins and baby dolphins.

A．Right

B．Wrong

C．Not mentioned

A. the st interface

B. the reth interface

C. the fxp1 and fxp0 interfaces

D. the fab0 and fab1 interfaces

What is the subject of the passage？

A．Language used to communicate ideas.

B．Differences between English and other languages.

C．A special social function of language use.

D．Relationship between language and culture.

A. A router connected to the fastethemet 1/4 interface will be able to communicate with hosts connected to interface fastethemet 1/1,1/2, and 1/3.

B. A router connected to the fastethemet 1/4 interface will not be able to communicate with the host connected to interface fastethemet 1/3.

C. Hosts connected to interface fastethemet 1/1 and 1/2 can communicate with each other.

D. Hosts connected to interface fastethemet 1/1,1/2, and 1/3 can communicate with each other.

ns．

A．Right

B．Wrong

C．Not mentioned

b-and-spoke Frame Relay topology shown in the exhibit. Originally, static routes were configured between these routers to successfully route traffic between the attached networks. What will need to be done in order to use RIPv2 in place of the static routes？（）

A.Configure the no ip subnet-zero command on R1, R2, and R3.

B.Dynamic routing protocols such as RIPv2 cannot be used across Frame Relay networks.

C.Configure the S0/0 interface on R1 as two subinterfaces and configure point-to-point links to R2 and R3.

D.Change the 172.16.2.0/25 and 172.16.2.128/25 subnetworks so that at least two bits are borrowed from the last octet.

E.Change the network address configuration to eliminate the discontiguous 172.16.2.0/25 and 172.16.2.128/25 subnetwork.