不属于业主应对所提供数据和资料的正确性负责的内容是（)。A．合同中规定监理工程师负责的和可变

A. in order to optimize the path that frames take from source to destination

B. to increase the priority so a designated port will become a root port

C. to increase the BID, so the switch is more likely to become root bridge

D. in order to allow VLANs to be sent from one switch to another across a single link

E. to force a given switch to become an STP server

witch？

A. in order to optimize the path that frames take from source to destination

B. to increase the priority so a designated port will become a root port

C. to increase the BID, so the switch is more likely to become root bridge

D. in order to allow VLANs to be sent from one switch to another across a single link

E. to force a given switch to become an STP server

F. None of the above

F to become the root bridge for a redundant path switched network. What can be done to ensure that this switch assumes the role as root bridge（）。

A.Establish a direct link from the switch to all other switches in the network.

B.Assign the switch a higher MAC address than the other switches in the network have.

C.Configure the switch so that it has a lower priority than other switches in the network.

D.Configure the switch for full-duplex operation and configure the other switches for half-duplex operation.

E.Connect the switch directly to the MDF router, which will force the switch to assume the role of root bridge.

VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.

Which of the conditions below have to be met in order for this to occur？ (Choose all that apply).

A. The switch that will share the VLAN information must be in the VTP Server mode.

B. The switches must be in the same VTP domain.

C. The switch that will share the VLAN information must be configured as the root bridge.

D. The switches must be configured to use the same VTP version.

E. The switches must be configured to use the same STP version.

F. The switches must be configured to use the same type of ID tagging.

G. The switches must be connected over VLAN trunks.

A new switch is installed in the Ezonexam network. This switch is to be configured so that VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.

Which of the conditions below have to be met in order for this to occur？ (Choose all that apply).

A. The switch that will share the VLAN information must be in the VTP Server mode.

B. The switches must be in the same VTP domain.

C. The switch that will share the VLAN information must be configured as the root bridge.

D. The switches must be configured to use the same VTP version.

E. The switches must be configured to use the same STP version.

F. The switches must be configured to use the same type of ID tagging.

G. The switches must be connected over VLAN trunks.

A．Sw-DS1

B．Sw-AC1

C．Sw-AC2

D．Sw-AC3

A．RIP

B．0S：F

C．STP

D．EGP

A．VTP

B．802.1Q

C．RSTP

D．STP

A.Cisco Catalyst 2000 and 3000

B.Cisco Nexus

C.Cisco Catalyst 4000 and 6000

D.Cisco SFS 3000/7000

An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location？ (Choose two)

A. The switch must be reachable through a port connected to its management VLAN.

B. The switch console port must be connected to the Ethernet LAN.

C. The switch must be fully configured as an SNMP agent.

D. The switch must be configured with an IP address, subnet mask, and default gateway.

E. The switch management VLAN must be created and have a membership of at least one switch port.

F. The switch must be connected to a router over a VLAN trunk.