屋面坡度（)时，卷材宜平行屋脊铺贴。A．小于3%B．3%～15%C．大于15%D．小于15%

A. EIGRP would be appropriate if LMI type ANS I is NOT used.

B. EIGRP would be appropriate, because the Frame Relay spokes could be segmented into their own areas.

C. EIGRP would be appropriate, because by default, queries are not propagated across the slow speed Frame Relay links.

D. EIGRP would be appropriate, because you can manage how much bandwidth is consumed over the Frame Relay interface.

A．EIA/TIA

B． Q.932

C． Q.933A

D． IEEE

E． Cisco

F． Annex D

w frame relay connection to a remote branch and wants to know what the valid options for frame relay LMI types are.What would your reply be？（）

A. EIA/TIA

B. Q.932

C. Q.933 A

D. IEEE

E. IETF

F. Cisco

G. ANSI

A. a traffic engineered path

B. another name for a Frame Relay PVC

C. a bidirectional path through a network

D. a unidirectional path through a network

A.point-to-point

B.broadcast multi-access

C.nonbroadcast multi-access

D.nonbroadcast multipoint.broadcast point-to-multipoint

A.point-to-point

B.broadcast multi-access

C.nonbroadcast multi-access

D.nonbroadcast multipoint

E.broadcast point-to-multipoint

The new location is using an Adtran router and you are having difficulties getting the site to connect via frame to your Cisco HQ router. What is the most likely cause of the problem？（）

A. Mismatched LMI types.

B. Incompatible encapsulation types.

C. Mismatching IP addresses.

D. Incorrect DLCI.

E. None of the above

A. Configure TCP header compression on interface

B. Configure MPL on the Frame Relay interfaces

C. Configure FRF 12 fragmentation on the Frame Relay interfaces

D. Fragmentation is not supported with service internetworking

on the TestKing2 Ethernet network can‘t access the TestKing1 site. Totroubleshoot this, you begin by looking at the Testking1 and Testking2 routerconfigurations as shown below:Based on the above output, what is the underlying cause of this problem？（）

A. Link state routing protocol is missing.

B. Incorrectly configured IP addresses

C. IGRP is incorrectly configured.

D. Frame relay is not configured.

E. None of the above