定额本票面额分别为()。

A.As numbers must be changed to match on all the routers.

B.Loopback interface must be configured so a DR is elected.

C.The no auto-summary command is needed on Router A and Router C.

D.Router B needs to have two network statements, one for each connected network.

Refer to the exhibit. All routers have Protocol Independent Multicast (PIM) enabled interfaces. On the basis of the configuration provided on routers R1 and R2, which router will take on the func tion of rendezvous point (RP) for the multicast network？ （）

A. both routers R1 and R2

B. router R1

C. router R2

D. none of the routers since they are not configured with static RP

A. Network B

B. Network A and Network B

C. Network A

D. neither Network A nor Network B

A. type 1 Router LSA

B. type 2 Network LSA

C. type 3 Network Summary LSA

D. type 4 ASBR Summary LSA

E. type 5 AS External LSA

F. type 7 NSSA External LSA

A. the serial 1/1 address

B. the serial 2/0 address

C. a randomly generated internal address

D. the configured router - id address

A. 10.0.0.0/8

B. 172.16.10.0/24

C. 172.16.0.0/24

D. 10.10.10.0/24

E. 172.16.0.0/16

F. 10.10.0.0/16

A. This is the designated router (DR) on the FastEthernet 0/0 link.

B. The output was generated by the show ip interface c ommand.

C. The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1

D. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.

E. Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command.

F. OSPF version 2 has been enabled to support IPv6.

A．10.0.0.0

B．10.0.0.254

C．192.223.129.0

D．192.223.129.254

A.The design will function as intended

B.Spanning-tree will need to be used.

C.The router will not accept the addressing scheme.

D.The connection between switches should be a trunk.

E.The router interfaces must be encapsulated with the 802.1Q protocol.

A. The no auto - summary command has not been issued under the EIGRP process on both routers.

B. Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24.

C. EIGRP cannot exchange routing updates with a neighbor‘s router interface that is configured with tw o IP addresses.

D. EIGRP cannot form neighbor relationship and exchange routing updates with a secondary address.