Theft deterrent system
To deter the vehicle theft, the system is designed to give an alarm and keep the engine from being started if any of the front, sliding and back doors and hood is forcibly unlocked or the battery terminal is disconnected and then reconnected when the vehicle is locked.
The alarm blows the horn intermittently and flashes the headlights, tail lights and other exterior lights. The engine cannot be started because the starter circuit will be cut.
SETTING THE SYSTEM
1. Turn the ignition key to the "LOCK" position and remove it.
2. Have all passengers get out of the vehicle.
3. Close and lock the front, sliding and back doors and hood.
The indicator light will come on when the front, sliding and back doors and hood are closed and locked.
As the front doors arc locked, the system will give you a preparation time of 30 seconds before the setting, during which the front, sliding and back doors and hood may be opened to prepare for the set- ting.
Be careful not to use the key when opening either front door. This will cancel the system.
4. After making sure the indicator light starts flashing, you may leave the vehicle.
The system will automatically be set after the preparation time elapses. The indicator light will flash to show the system is set. If any of the front, sliding and back doors and hood is opened at that time, the setting is interrupted until it is closed and locked.
Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate (使起动) the system.
WHEN THE SYSTEM IS SET
Activating the system
The system will give the alarm and cut the starter circuit under the following conditions:
If any of the front, sliding and back doors and hood is unlocked without using the key
If the battery terminal is disconnected and then reconnected
After one minute, the alarm will automatically stop with the starter circuit cut kept on.
Reactivating the alarm
Once set, the system automatically resets the alarm each time the front, sliding and back doors and hood are closed after the alarm stops.
The alarm will be activated again under the following conditions:
If any of the front, sliding and back doors and hood is opened
If the battery terminal is disconnected and then reconnected
Stopping the alarm
Turn the ignition key from the "LOCK" to "ACC" position. The alarm will be stopped with the starter eircuit cut kept on. Stopping the alarm in this manner will keep the alarm from being reactivated when any of the front, sliding and back doors and hood is opened.
Interrupting the setting
With the system set, the back door can be opened with the key without activating or canceling the system. While it is open, the front and sliding doors and hood may be opened in addition, and the system can be activated only by the battery terminal disconnection.
To resume the setting, close and lock the front, sliding and back doors and hood. The back door must be closed with the key removed.
CANCELLING THE SYSTEM
Unlock either front door with the key, or unlock the sliding door with the key when it has been closed. This cancels the system completely and the starter circuit cut will be cancelled at once.
INDICATOR LIGHT
The indicator light gives the following three indications when the system is in use. When the light is:
FLASHING—The system is set. You need the key to open the front, sliding and back doors and hood.
ON—The system will automatically be set when the time comes. The front, sliding and back doors and hood may be opened without a key.
OFF—The system is inactive. You may open any door and hood.
TESTING THE SYSTEM
1. Open the driver's and front passenger's windows.
2. Set the system as described above. The front doors should be locked wi
A.Y
B.N
C.NG
第2题
GB/T1576水质标准中,对于锅水的硬度无标准规定,是因为()。
A.锅水中硬度对锅炉无危害
B.锅水中不会有硬度
C.锅水中保持一定的碱度可除去残余硬度
D.硬度已转化成水垢
第3题
橡碗栲胶作锅内水处理剂的主要作用有()。
A.与硬度物质络合,防止结垢
B.提高锅水碱度
C.破坏金属表面膜
D.提高PH值
第5题
锅炉底部排污的主要作用是_________。
A.降低锅水碱度
B.排除底部泥渣和沉淀物
C.降低锅水硬度
D.A和B
第6题
锅炉不能用上排污来保证锅水质量的情况是_________。
A.投药不当使碱度太大
B.锅水含盐量太高
C.水面上有油污、泡沫与浮物
D.锅水硬度太大
第7题
热水锅炉锅水超温汽化的现象之一是锅水()突然升高,安全阀动作。
A.水位
B.碱度
C.压力
D.浓度
第9题
A.锅水中的硬度对锅炉无害处
B.锅水中不会有硬度
C.锅水巾保持一定的碱度可除去残余硬度
D.硬度已转化成水垢
为了保护您的账号安全,请在“上学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!