A.集体土地上的合法房屋
B.代管房屋
C.列入拆迁范围内的房屋
D.共有房屋
E.商品房预售许可证正在办理之中的房屋
第1题
A.R2(config)# ip route 192.168.1.0 255.255.255.0 10.1.1.1
B.R2(config)# ip route 192.168.1.1 255.255.255.010.1.1.2
C.R2(config)# ip route 192.168.1.2255.255.255.010.1.1.1
D.R2(config)# ip route 192.168.1.2255.255.255.010.1.1.2
第2题
A.R2 (config) #ip route 192.168.1.5.0.0.0.255 10.1.1.2
B.R2 (config) #ip route 192.168.1.5 255.255.254.0 10.1.1.2
C.R2 (config) #ip route 192.168.1.5 255.255.255.0 10.1.1.2
D.R2 (config) #ip route 192.168.1.5 255.0.0.0 10.1.1.2
第3题
以下是路由器R2的配置命令列衣,请将(4)~(6)空缺处的命令/参数填写完整,以实现路由器R2的正确配置。
Router>en
Routerconf term
Router (config) hostname R2
R2 (config) int e0
R2 (config-if) ip address (4)
R2 (config-if) no shutdown
R2 (config-if) int s0
R2 (config-if) ipaddress 192.168.2.2 255.255.255.0
R2 (config-if) no shutdown
R2 (config-if) (5)
R2 (config) ip routing
R2 (config) ip route 0.0.0.0 0.0.0.0 (6)
R2 (config) ip classless
R2 (eonfig) exit
R2copy run start
第4题
某单位采用双出口网络,其网络拓扑结构如图5—12所示。
该单位根据实际需要,配置网络出口实现如下功能:
1.单位网内用户访问IP地址158.124.0.0/15和158.153.208.0/20时,出口经ISP2;
2.单位网内用户访问其他IP地址时,出口经ISPl;
3.服务器通过ISP2线路为外部提供服务。
在该单位的三层交换机S1上,根据上述要求完成静态路由配置。
ip route(1)(设置默认路由)
ip route 158.124.0.0(2)(3)(设置静态路由)
ip route 158.153.208.0(4)(5)(设置静态路由)
第5题
A.R2(config)# ip route 172.16.2.1 255.255.255.0 172.16.3.1
B.R2(config)# ip route 172.16.2.0 255.255.255.0 172.16.2.254
C.R2(config)# ip route 172.16.2.0 255.255.255.0 172.16.2.254
D.R2(config)# ip route 172.16.3.0 255.255.255.0 172.16.2.254
第6题
下面是公司总部的路由器R2的配置命令列表,在空白处填写合适的命令参数,实现R2的正确配置。
Router>an
Routerconf term
Router(config)hostname R2
R2(config-if)int s0
R2(config-if)ip address [ (4) ]
R2(config-if)no shutdown
R2(confiq-if)exit
R2(config)ip routing
R2(config)ip route [ (5) ]
R2(config)ip classless
R2(config)exit
R2copy run start
第7题
A.ip route 192.168.3.0 255.255.255.0 192.168.2.1
B.ip route 192.168.3.0 255.255.255.0 192.168.2.2
C.ip route 192.168.2.0 255.255.255.0 192.168.2.2
D.ip route 192.168.2.0 255.255.255.0 192.168.2.2
第8题
R2(config)interface fastethernet 0/0.1
R2(config—subif)encapsulation dotl q(3)
R2(config—subif)ip address 202.1 14.12.1 255.255.255.192
R2 f config—subif)no shutdown
R2(config—subif)exit
R2(config)interface fastethemet 0/0.2
R2(config—subif)encapsulation dotlq(4)
R2(config—subif)ip address 202.1 14.12.65 255.255.255.192
R2(config—subif)no shutdown
R2(eonfig—subif)exit
R2(config)interface fastethernet 0/0.3
R2(config—subif)encapsulation dotl q(5)
R2(eonfig—subif)ip address 202.1 14.12.129 255.255.255.192
R2(eonfig—subif)no shutdown
R2(config—subif)exit
R2(eonfig)interface fastether0/0
R2(config—if)no shutdown
Switch0(~onfig)interface f0/24
Switch0(config—if)switchport mode(6)
Switch0(config—if)switchport trunk encapsulation(7)
Switch0(config—if)switehpoa trunk allowed all
Switch0(config—if)exit
为了保护您的账号安全,请在“上学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!