根据发行主体的不同，债券可分为()。

ther switch from a different vendor, which uses the IEEE standard for the trunking method.When setting the encapsulation type on the trunk, what should you configure on the Cisco switch？（）

A. Switch(config)# switchport trunk encapsulation isl

B. Switch(config)# switchport trunk encapsulation ietf

C. Switch(config-if)# switchport trunk encapsulation isl

D. Switch(config-if)# switchport trunk encapsulation ietf

E. Switch(config-if)# switchport trunk encapsulation dot1q

an existing switch. Which VLANs will be allowed on this new trunk？

A．All defined VLANs are allowed on the trunk by default.

B．Each VLAN, or VLAN range, that is specified with the switchport mode command.

C．Each VLAN, or VLAN range, that is specified with the vtp domain command.

D．Each VLAN, or VLAN range, that is specified with the vlan database command.

E．None of the above

u are instructed to enlarge the area covered by a single LAN segment on the Ezonexam network.

Which of the following are layer 1 devices that you can use？ (Choose all that apply.)

A．A switch

B．A router

C．A network adapter card

D．A hub

E．A repeater

Which of the following need to be completed for the creation of this new VLAN？ (Select all that apply)

A. The EZONEXAM VLAN must be created.

B. The desired ports must be added to the new EZONEXAM VLAN.

C. The EZONEXAM VLAN must be added to all of the domains.

D. The EZONEXAM VLAN must be named.

E. An IP address must be configured for the EZONEXAM VLAN.

F. None of the above. VLAN creations are automatic.

e purpose of assigning an IP address to a switch？

A．To provide local hosts with a default gateway address

B．To allow remote management of the switch.

C．To allow the switch to respond to ARP requests between two hosts

D．To ensure that hosts on the same LAN can communicate with each other.

E．None of the above

A new switch is installed in the Ezonexam network. This switch is to be configured so that VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.

Which of the conditions below have to be met in order for this to occur？ (Choose all that apply).

A. The switch that will share the VLAN information must be in the VTP Server mode.

B. The switches must be in the same VTP domain.

C. The switch that will share the VLAN information must be configured as the root bridge.

D. The switches must be configured to use the same VTP version.

E. The switches must be configured to use the same STP version.

F. The switches must be configured to use the same type of ID tagging.

G. The switches must be connected over VLAN trunks.

You can hardly imagine the difficulty the single mum had ______ her children.

A. brought up

B. to bring up

C. bringing up

D. to have brought up

k of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches. Which of the following must you do to accomplish this？ (Choose all that apply).

A．You must set each end of the trunk line to IEEE 802.1e encapsulation.

B．You must set the same VTP management domain name on both switches.

C．You must set all ports on the two switches as access ports.

D．You must configure one of the switches as a VTP server.

E．You must use a rollover cable to connect the two switches.

of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in the Ezonexam network.

However, you need to share the VLAN information across numerous switches. Which of the following would allow you accomplish this？

A. STP

B. GVRP

C. SNMP

D. VTP

E. DHCP

F. None of the above